Question:
Do you have a guide on how to put up the design in the FMX Display on a Trimble Field Level II?
Answer:
You want to follow the same procedure as "Working With Multiplane designs' in the FMX manual to load the .gps file. If you have FMX Firmware version 7 or higher, then create a new field and operation with NO Master Benchmark in it and then open that Field and load the design.
Remember to load the design in a new field without any benchmarks. Be sure to re-bench after importing the design.
Below show some clips from FMX User Guide v7.2a
1. Copying the .gps File Into the USB Stick
2. Field Level II Setup
3. Creating a Field
Open the Existing Field in FMX that was used during the survey. If this does not exist, create a new field and open it.4. Working with .gps Files
5. Re-benching
