Overview: Updates the Cut/Fill Map, slopes and earthworks volume after the Proposed Topography has been modified using breaklines or the topographic points are edited/deleted after the Landform Design calculation.
Displayed by: Tools > Recalculate Cut/Fill
Or
Appearance:
- Main Slope Bearing (deg) - Defines the direction of the main slope or down slope. It should generally have the same value as the Main Slope Bearing defined in Landform Design.
- Boundary Point Spacing (m or ft) - Defines how far apart the calculation points for the recalculation. Lowering this to 5m or less will result to more accurate earthworks.
- Rebalance - Tick this ON to rebalance the earthworks on recalculate using defined parameters as shown below.
Cut/Fill Ratio - Cut/fill ratio = Volume of Cut / Volume of Fill. It is the same as the ratio used in Landform Design.
Fill to Import (m3 or ft3) - Add in a value other than 0 if there are fills to be imported into the field.
Cut to Export (m3 or ft3) - Add in a value other than 0 if there are cuts to be exported out of the field.
Adjust Breaklines - Tick this ON to and allow the breaklines to shift vertically to balance the earthworks.
Cut/Fill Map (No Recalculate Cut/Fill)
Cut/Fill Map (Recalculated)
